Often Free shipment in Europe

Makeblock Me Auriga without Bluetooth Module


Write a review

1 item left

Category: arduino, electronics, main control boards, me module,

Me Auriga Overview

The Makeblock Me Auriga is the updated version of the Orion equipped with several additional sensors. The previous two red ports have been changed into four but with the same functions. Also, PORT5 is isolated and only with serial communication function. So it can't be used to update program and is only for communication. Also, it is compatible with USB serial port. PORT6 to PORT10 are compatible with dual-digital, simulation, I2C bus, unibus, and simulated serial port. Me Auriga has an encoder motor port, smart servo port and LED Ring Panel port (with a power switch). Besides, the PCB is also enlarged.



  • Easy to connect with sensors, electronic modules and motor drives;
  • Support DC motors, stepper motors, servo motors, smart servos, encoder motors, etc;
  • Drive two encoder motors at the same time; Over-current protection – 2.4A (instantaneous);
  • One power switch to control the whole circuit;
  • PORT5-PORT10 support continuously 5V 2.4A output (up to 3A);
  • PORT1-PORT4 support continuously 3.5A output (up to 5A);
  • PORT5-PORT10 support short-circuit protection and over-current protection for 3A;
  • PORT1-PORT4 support short-circuit protection and over-current protection for 3.5A;
  • USB port with antistatic protection;

  1. Gyroscope
  2. Sound sensor
  3. Passive buzzer
  4. Temperature sensor
  5. 12 PXL LED RGB panel with light intensity sensor


  • Compatible with ARDUINO IDE;
  • Compatible with RJ25 port;
  • Special library for Arduino; powerful and easy to understand;
  • Support Bluetooth and Bluetooth upgrade firmware.

△ Note

The plastic case is a little difficult to open, so please slightly pry off its corners first, then open it. See the GIF.



Output Voltage                 5V DC & 6 - 12V DC                
Input Voltage 6 - 12V DC
Maximum instantaneous output current (PORT1-PORT4) 5A (continuous output: 3A)
Maximum instantaneous output current (PORT5-PORT10) 3A (continuous output: 2.4A)
Communication Mode UART, I2C, digital input/output, analog input/output
Main Controller Atmega 2560
Circuit Board Dimension 100 x 65x 18 mm (L x W x H)
Package Dimension 188 x 150 x 29mm (7.40 x 5.90 x 1.14inch)
Product Dimension 109 x 88 x 27mm (4.29 x 3.46 x 1.06inch)
Part List Me Auriga V1.0 x 1(Bluetooth Module Excluded)
Me Auriga Case x 1


Related Items

Makeblock Shop - Educational STEM and STEAM Open-Source Robots with Arduino and Scratch. Maker of mBot, Starter Robot, mBot Ranger, Ultimate Robot, Airblock, Neuron and LaserBot.